英语翻译
note:
1.material polished 0.6mm/0.24 in.thick 300 series stainless steel.
2.specification #70-303(U.L TEST FOR SHARP EDGES)SHALL APPLY .
3.the geometry and surfaces shown in this drawing are merely a two dimensional (2d) representation of the part.actual geometry and surfaces are accurately represented in the 3d part computer file.all reference(ref.) and non-dimensioned geometry and surfaces can only be created using the 3d part computer file.only dimensions shown that are not reference may be used to create the part.dimensions are mm/inch.
unless otherwise specified
1.do not scale drawing.
2.remove all burrs & sharp corners.
3.dimensions:decimal inches
millimeters
4.tolerance on dimensions.inches millimeter
THREE PLACE DECIMAL
TWO PLACE DECIMA
HOLES ON CENTERLINES WITHIN
ALLOWABLE ECCENTRICITY
ANGULAR